Package
Please make sure the following contents are in the PA730 gift box.
If something is missing or damaged, please contact
your unitech representative.
The
basic package contents
PA730 Terminal
Regulatory Compliance Statements
USB Cable
Power Adapter (EU or US )
Battery
Hand Strap
Quick Start Guide
Rugged Handheld Computer
- PA730 -
Quick Start Guide
-1-
401294G V1.0
Product V
iew ( Front View )
1. Front Camera 6
Camera Button
2.
Logo 7 Speaker
3.
Back key
8 Light Sensor
4.
Home Key 9 LED
5.
Menu key
Product View ( Rear View )
1
Battery Pin
5 Hand Strap hook
2 6 Back Camera
SIM Card Slot
3
Micro SD Card Slot
7 Flash LED
4
Battery Cover lock
Switch
-2- -3-
Product View ( Side View )
Product View (T
op & Bottom View )
1 Scan Window
1 Cradle IO connect
1 Ear Phone Jack 5 Scan Button
2 Scan Button 6 Volume Up
3 Function Button 7 Volume Down
4 Power Button 8 USB Connect
CAUTION!
To ensure the unit working properly, please keep all connectors
away from the contaminants staying inside of them such as dust,
grease, mud, and water. The negligence may cause the unit with
no communication, short circuited, overheated and so on.
-4- -5-
If the connector is damaged, please ensure the connector is being
fully repaired before using the unit to avoid causing short circuited.
http://www.ute.com/
Copyright 2017 unitech Electronics Co., Ltd. All rights reserved. unitech is a registered trademark of unitech Electronics Co., Ltd.
Turning on the terminal for the first time
PA730 is shipped with Lithium-ion battery but not fully charged. Please fully
charge it before the 1st time use under the environmental temperature of
0℃～40 .℃
Battery installation
PA730 battery pack is not initially fully charged. After installing the battery
pack, please charge it via the USB cable or the charging cradle.
As default, the battery pack is disconnected at the factory to avoid damage
caused by excessive draining. Avoid storing batteries for long period of time
in fully charged or very low battery level status.
Please remove the hand strap first when opening the battery compartment.
Please push the battery Cover Lock Switch to open position then remove the
battery cover.
1
Battery Slot
2
Battery Pack
3
Battery Cover
SD / SIM Card inst
allation
1. Turn off PA730 or put it in Battery Swap Mode
2. Remove the battery cover
3. Remove the battery pack by pulling the tab on the end of the battery
4. Lift the retaining door
5. Insert the micro SD card into the left slot
6. Insert the SIM card into the right slot
7. Insert the battery pack into the battery compartment.
8. Restore the battery cover and lock the battery cover lock switch
Imager data capture to scan a barcode label
1. Point the scan window at the barcode
2. Tap Scan on the screen or press one of the scan buttons on PA730.
The imager will project a laser aiming pattern.
3. Center the barcode in any orientation within the aiming pattern. Ensure
the entire barcode is within the rectangular area formed by the brackets
in the aiming pattern, then either wait for the timeout or release the scan
key to capture the image. A red light will illuminate the barcode to
capture and decode it.
-6-
-7-
